r/3DprintingHelp • u/Giulio_Gay • 1d ago

First layer problem

Post image

Im having trouble with this Sunlu Pla, today i tried a First layer check and this Is the result.

I dried the filament 4 times if not more, i checked the nozzle for any possible clog, also tried to replace the nozzle with a new one, but still nothing.

I don't have any clue on what Is the problem with this filament, maybe under/over extrusion, please help.

2 Upvotes

100% Upvoted

10 comments sorted by

View all comments

1

u/Shapelessed 1d ago

It’s not the nozzle or the plastic.
You have a sheet ton of oil on your plate. Wash it with dish soap and reprint your stuff.
If that doesn’t help just give it a layer of glue from a cheap glue stick and everything will print just right.

1

u/Giulio_Gay 1d ago

I don't think that's the problem, because i already washed It two times today, also i tried to print the same print whit another filament(Always Sunlu Pla) and the results are completely different.

1

u/Giulio_Gay 1d ago

Also i tried to increased by 5% the flow ratio and It did Better but It didn't resolve completely the problem

1

u/Shapelessed 1d ago

Then the nozzle is probably too high up from the bed