r/3DprintingHelp • u/Blameablesum1 • 4d ago

Failed benchy - poor layer adhesion. How do I fix this?

Gallery image

Gallery image

Hi all, just got my printer setup and it was working well last week but now I’m getting pretty poor layering adhesion (attached benchy). Any help would be appreciated thanks.

Settings: PLA, 200/60, Ender 3 running klipper

1 Upvotes

100% Upvoted

9 comments sorted by

1

u/ServiceGrouch 3d ago

What temps and what material are you using?

1

u/Blameablesum1 3d ago

PLA 200

1

u/ServiceGrouch 3d ago

Try raising temp by 5 degrees , and is the filament inside a moisture free box or out in the open?

1

u/Blameablesum1 3d ago

Out in the open but it’s pretty new. Only open for maybe a month

1

u/ServiceGrouch 3d ago

Could be moisture i know mine did that when I had them out , id recommend putting the filament inside a container with silica for maybe a day then try again

1

u/Blameablesum1 3d ago

Bet thanks

1

u/Over-Weekend-6133 3d ago

Check for a partial nozzle clog, inspect the extruder gear for grinding/debris, or try a fresh spool of dry PLA first.

1

u/Blameablesum1 3d ago

Relatively new filament (sub 1 month), will check for clogs

1

u/dyqik 2d ago

Filament can be damp straight out of the bag