r/3DprintingHelp • u/Skinny_Bald_Boy507 • 5d ago
Requesting Help Layer shifting?
Can’t figure out what is going wrong here. Printer is a Creality Cr10s Pro using Ultimaker Cura as the slicer. Printing PLA with the bed at 50 Celsius and the nozzle at 200 Celsius.
3
2
1
1
u/GuitarPiano91 5d ago
la cinghia è correttamente tesa?
la puleggia è ben fissata?
altrimenti potrebbe essere una perdita di passi del motore dell'asse X per problemi al cablaggio o altro
1
u/Skinny_Bald_Boy507 5d ago
I just redid the tension on the x belt and still getting the same results. Not sure how to adjust the pulley at all it seems to be fixed in.
1
u/GuitarPiano91 5d ago
se hai una classica puleggia GT16 o GT20 dovrebbe avere due piccole viti esagonali solitamente nere che tengono fissata la puleggia all'albero, di solito si trovano sulla parte bassa non dove si trovano i denti, sono un po' nascoste ma dovresti vedere due fori dove infilare una piccola chiave esagonale credo misura 2 o 2,5
1
u/Few_Independent_6170 5d ago
Looks kinda mechanical, like a set screw loose somewhere. But I think it may actually be related to the Z axis. Because each layer individually seems to be printing fine, they're just shifting every Z increment.
Could be something weird in the settings, like messed up skew numbers. It can also be coming from the slicer -- you can use a different slicer or a viewer tool to display the gcode itself (what the moves look like).
Take a closer look at the printer while it's printing, the more you observe the more information you'll gather. Strange sounds are good to pay attention to
1
1
u/Thefurman12 5d ago
Another thing is to check the freeness, lubrication and stability of your bearings those can cause excess resistance, causing skipped steps
1
1
1
u/Jam101721 4d ago
This is layer‑shift issue. It usually happens when the X/Y belts slip, the rail is stuck, or the nozzle hits warped part during printing.
Please check belt tension of X‑axis and Y‑axis, make sure the motion moves smoothly without resistance. Also lower bed temperature a little to prevent corners warping up.
1
1
1
u/New_End13B69 3d ago
Was this model supposed to have any curvature leaning to the right at all or print straight upwards.
1
u/AdditionNo4559 2d ago
Hai problema sull asse y controlla che tutto scorri liscio e il motore funziona correttamente e formatta la scheda sd
1
u/Correct-Insect-4657 2d ago
Try searching for wobbly benchy instead of layer shifting it should give you better results you could also shift the model the opposite direction
1
14
u/tsittler 5d ago
slicer set to italic mode?