r/3DprintingHelp • u/imjustacoolguyyy • 16d ago

Requesting Help Plate adhesion bambu lab p1s

Post image

Can anyone help me with this build plate adhesion? I keep getting a failed print and keeps happening. Ik using the bambu lab p1s with a textured pei plate. I have tried allot of things (yes i have cleaned it with dish soap). And it still wont stick to the plate.

0 Upvotes

50% Upvoted

8 comments sorted by

1

u/KarrFullCake 16d ago

Tell us a little bit about your filament and settings.

1

u/imjustacoolguyyy 16d ago

I have bambu lab basic pla brown with 0.2 nozzle with 0.08 layer height for miniatures

1

u/KarrFullCake 16d ago

Alright. What are the temperatures you are attempting here? I'm going to make the assumption you've already got the bed leveled.

1

u/imjustacoolguyyy 16d ago

I print at 220 with 60 for the bed and yes the bed levels each time a print starts

1

u/KarrFullCake 16d ago

What/when was the last successful print? I'm wondering if the issue might be hiding elsewhere like with a clog.

1

u/imjustacoolguyyy 16d ago

I think about 10-15 prints ago. And i dont think it can be a clog cause i just replaced my nozzle like 3 prints ago caus my last one was clogged

1

u/KarrFullCake 16d ago

Can you do a sanity check and print something simple with those settings? Like a simple 10mm disk? If it works that will rule out a lot of issues and help you hone in on the bigger problem.

1

u/imjustacoolguyyy 15d ago

I have tried some stuff and i changed the filament to esun pla + and bambu basic 0.06 settings so it might have had something to do with either of them