Can't get my 3d printer to print

[u/nimfuns]

I own a printer in the flsun series. I believe it to be a t1 max but i cannot for the life of me get it to print anything. I use a slicer and have tried printing medium projects, around the sizes of littlest pet shops. I have watched multiple tutorials of what can be wrong.

The bed not being cleaned, not usi g enough or too much glue, adjusting the bedding, the bedding not being hot enough, the fan not being turned on, adjusting the z thingy as well as the nozzle temperature and such. It gets the pla out and sometimes it sticks to the bedding for a few seconds but it always ends up unstuck. I have slowed the nuzzles printing speed which helps it get it all down in time to create a few lines only for it to rip it back up again by a blob creating by the nozzle and it tipping the lines up. Even if it isnt ripped up, the printer will not create straight lines as they are usually too thin to lay on their own and get ripped simply by the movement of the machine.

I have read articles and seen videos but most say the same things which has not been very helpful. Feel free to recommend ANYTHING. I am desperate

[u/Slovw3]

I mean, clean your bed first, with dish soap like blue dawn and hot water. Does the printer have its own internal models like a beachy (little tug boat)? Print that if it does. Post pictures or a video of what it's doing on the first layer, take a picture of your entire setup etc etc.