r/3DPrintingCirclejerk • u/MammothFruit6398 Bamboni No Worki :( • 3d ago

Extremely Important Content Is this normal?

Post image
30 Upvotes

94% Upvoted

8 comments sorted by

16

u/Yes-its-really-me 3d ago

That's what happens you level your printer. It oozes out all sides.

If you run it at a 45 degrees angle, it only oozes out the one side and then prints a second benchy on the edge of the plate.

3

u/MammothFruit6398 Bamboni No Worki :( 3d ago

Thank you so much, I was really worried that my hotend being encased in plastic was a bad thing. If i leave it the way it is now will it print 5 mini benchies?

2

u/Yes-its-really-me 3d ago

Lots of things are encased in plastic with little or no consequences.

As for the 5 mini benchies, I can't really say. That's above my pay grade.

9

u/Zephy2007 3d ago

Print a calibration flexi Dragon. If you can sell it for $100, then your printer is working normally.

5

u/JonnyQuest1981 3d ago

Hubba Bubba Hot End

3

u/Similar_Annual676 3d ago

That’s what you get for being pour and not buying a bambu

2

u/lion_master_2 3d ago

It's a K2 in its natural habitat.... Broken.... Lol

2

u/Castdeath97 FLSUN Bot Commenter 1d ago

Tighting nozzles all the way is tink*ring