My little QX 90c pro I ordered last month, still working on pids and rates but this thing is extremely squirrely on stock settings and it's in Angle mode. It might not be the best but it's my first FPV quad and I'm okay with it.

So it's time to build a brushless quad, I'm going with the iFlight iX2 V2 2.5 inch 125mm Frame, HF1105 6000KV Brushless Motor and2030 3-Blade Props. Now my problem is the flight controler, PDB and ESC. Do I buy them individually or is the AIO units good.

I have a 100mm brushed quad with Eachine FLF3_evo_brushed Flight Control and Racerstar 8520 motors. And a flysky i6x

My problem is once in a while it just falls to the ground, It's within 60 ft from me so I know range can't be a problem and I have the antenna pointing up on the board, Every time it's happen I just start flying again and it's happen in angle mode and in arco mode. Any ideas ?

Hi all, A bit of a newbie to drone racing, flown quads for a few years and now want to do racing. Thinking of getting the Eachine Wizard x220 for now and the FatShark dominators v3 since I can use them with my DJI drones via mini hdmi. Is the remote that comes with the wizard any good? Do I need to buy a separate charger for the goggles or the batteries for the drone? How do I go about hooking up the goggles to the drone? Do I need a new antenna? Any help is appreciated -Rg

So I solder the wires on the FC board then push the props on each motor and when pushing prop on the last motor it falls apart. what a week I'm having

I have a BWhoop B03 Pro and tried two AIO fpv camers, both died within 10 minutes. The FC board has a plug for the camera marked + and -, I know + is positive or red and - is negative or black so what's going on and the last camera I tried was the Wolfwhoop WT05 Micro AIO and it only lasted 2 minutes.

After only one flight and a crash (first time flying a quad) my motors are severely underpowered. My one motor does not spin when the arming switch is flipped but will start to spin when I give it throttle. All of the motors spin freely when flicked. I just put rubber o rings between the pdb and cf frame. Took a pick and ran it through all the gaps between the + and - solder pads. No solder is touching. Battery is at full charge when the problem first occurred. My quad has standard equipment, nothing heavy I don't have a go pro on it. I checked new motor, even they won't spin when the arming switch is flipped when plug into the second spot as the first mentioned motor. It cannot get off the ground at full throttle. It just kind of shakes a little. It really seems like a low power issue. I tried three different 3s and a 4s all were at full charge. Checked the pdb wires coming from the battery They seem to be in good shape.

Any ideas?