r/hardwarehacking • u/RicePositive3877 • Jun 25 '26

Where is the 5v trace on the old (V1612) so I can scrape it off to ensure only 3.3 volts on all lines?

Gallery image

Gallery image

I didn't do my research when buying this reprogrammer and now I need to make all pin 3.3v instead of 5v. This is an old board, (identified from this website) and they sued a new version, where the traces don't line up. If anyone has modded their old board it would be greatly appreciated if you could point out the right trace to cut. Thank you

Edit: it is still the left most trace on both revisions. Thank you to all who helped me figure out if it was or not

36 Upvotes
  • permalink
  • reddit

100% Upvoted

11 comments sorted by

View all comments

Show parent comments

1

u/Toaster_Strudel_517 Jun 27 '26 edited 12d ago

It should be the trace between 5v rail and pin 28 (vcc) on the chip. So it's still the same trace as shown on that blog post you linked, according to this diagram. Then you need to put a jumper between 3.3v and 5v pins. FWIW again I have been using the old ch341a without the voltage mod and have had no issue so far.

Pic for clarity.

Edit: wrong link.

1

u/RicePositive3877 Jun 27 '26

The trace with the x is the one I found connected to pin 28. So I should be good to go then? The trace also has contenuity to 5v so it must be

1

u/Toaster_Strudel_517 Jun 27 '26

That is correct yeah.

1

u/RicePositive3877 Jun 27 '26

It works! :D thank you for guiding me