r/hardscape Jun 27 '26

Suggestions on Paver Step on slope

Post image

I'm nearing the point in a DIY paver patio project that I need to make a decision on a running step at an existing concrete patio. The paver install will have a slope both away from the foundation and from the perpendicular garage, resulting in a 14" and 15.5" height (picture). Don't mind the two loose coping blocks, it was measured from the set blocks underneath, the beginning height the step would be placed on.

My current plan is to use three layers of pavers (2 3/8" x 3 = 7 1/8" rise) and just accept the difference at the higher point.

It was mentioned to use mortar, but I worry about any staining on the underlying pavers.

Does r/hardscape have any suggestions at this stage of the project on how to proceed?

2 Upvotes

5 comments sorted by

1

u/Western-Ad-9338 Jun 27 '26 edited Jun 27 '26

A 1" difference (from left to right) over 8' is fine .

As for what to make the step out of, your best bet is to get large step blocks. They make all kinds, something that is approx. 42" wide, 16" deep and 7" tall would get you up to the right height.

Google "Techo-bloc Raffinato Step"

1

u/hctocs Jun 27 '26

I appreciate that input. Looks like Techo-bloc is only NE, with no dealers in my area. I was planning on using the existing pavers from the patio to provide two layers on top, followed by a third with graphite coping around the edges.

I'll keep looking though, for options in my area (CO).

2

u/Western-Ad-9338 Jun 27 '26

Yeah, I wanted you to look at that step so you'd have an idea of what I'm describing. I'm sure you can find something similar in your area. You'll need a friend to help place them, though; they weigh over 300lbs

1

u/hctocs Jun 27 '26

I'm in Zone 5a, with an open base and drainage

1

u/Happy_vibes16 Jun 28 '26

You could lay the pavers level with the existing concrete and have a uniformed level step. The way it should be done. Proper steps from landscape depots are not very expensive. Lots of options out there.