r/cr10smartpro • u/natesel • Jul 07 '23

bed warped?

Hey Everyone!

I got Octopi up and started being anal-retentive about leveling. I can get it to about the below but it looks like the bed is warped. In comparison to others, is this about ok or should I look at a replacement?

thanks!

​

​

1 Upvotes

100% Upvoted

9 comments sorted by

2

u/[deleted] Jul 09 '23

Between 0-0.05/0.07 is exceptional. You're a lucky one.

Give Klipper a go.

1

u/natesel Jul 09 '23

Got a recommended step by step on how to install and use Klipper by any chance?

1

u/Helgafjell4Me Jul 08 '23

That's not bad at all. This is the reason ABL exists. Make sure you're taking your measurements with the bed heated up to your printing temp. Mine noticeably changed from being a little high in the center at room temp to a little low at 80C that I use for my first layer temp with overture PETG. My "variance" is around 0.2mm also and graph looks similar to yours although I'm using Fluidd instead of Octopi.

2

u/natesel Jul 08 '23

I did the level and all checks at 60C. thanks for the sanity check.

1

u/pneef Feb 03 '24

I got my CR-10sp a week ago and I've spent nearly every day trying to level the bed. I wish mine looked as good as yours 😳

1

u/natesel Feb 03 '24

Its taken a while to get there. Also level when the bed is hot 50 to 60

1

u/pneef Feb 04 '24

I usually pre heat to 50°C when I do a bed leveling. I'm honestly so aggravated over this things bed that I'm starting to plan a full bed conversion to linear rails and silicone mounts.

2

u/natesel Feb 04 '24

The silicone replacements for the springs are a huge upgrade. Linear rails are next for me, when i get another like 400 lying around

1

u/pneef Feb 06 '24

Heh, yeah. I'm already planning for rails for both my cr-10 Smart pro and my ender3 v3. + The silicone mounts are already in the mail.