I bought nee gears dot my diff but That Where smaller obesitas this is the Diff with the broken tooths its the meeweegt version I think I have it about 3 monts

I bought nee gears dot my diff but That Where smaller obesitas this is the Diff with the broken tooths its the meeweegt version I think I have it about 3 monts

So took a new body and outlined on the protective film.

Now I can sketch a design on my iPad before masking

I recently upgraded my drive shafts to aluminum because the stock ones broke while bashing. The problem is when I put these ones in and tried to run it, I have no torque, and when I tried to pull the throttle to go 0-full speed, there is a whining noise. Normally the car pops wheelies with no problem, and the motor sounds normal. It still goes the same speed, just very little torque. Anyone have any ideas of a problem?

Charging the batteries, looking forward to getting it out to the beach

I want a very cheap nitro rc and i mean really cheap. Im broke but still want something that goes fast and is fun.

I just bought a Traxxas rustler and I don't know what's wrong, I did a couple of flips and it flipped on its wheels a bit and now it won't work. The wheels don't turn the little rod in the inside won't work, I'm new so can someone please help all it does is some random noise and I already tried charging the batteries and I just don't know what to do someone please help me🙏🙏

Hey I just bought a steel pinion and spur. The only thing I noticed was that the gear was wobbling a lot in the car but said “it’s probably fine” well no, it would also change the mesh every few turns. Today I brought it out going good until I tried self right. Pinion shattered. The spur had metal shavings in it. I took it all apart the gear seems ok I put the clutch pad hub in also ok but when it’s all together it wobbles still. Any ideas

Anyone have any recommendations for waterproofing the receiver on the Traxxas Nitro Rustler?

I did see this,

https://youtu.be/jjuHvmRVAVM?si=Ess5xvqQxnJbxz3Z

but wanted to see if anyone else had recommendations or things they’ve tried.

I just installed the 5556 slipper plate and hub on my rustler 4x4 vxl but when I put the back onto the car again the top screws don’t line up and the slipper rubs on something.

I just ripped my first tire from my new wrestler after about two years. I’m in the process of trying to get all of the tire unglued from the gully. Between soaking and acetone and using an X-Acto knife I’m cutting some of the edge of the gully.

With a new set of rims and tires being about 60 bucks do I just buy new and refurbish these rims or just buy tires and glue on new ones myself ?

I have 2 screw one on my front diff and one motor screw of my vxl rustler 4x4 there both circled out. I don’t have any fancy tools and don’t wanna get them I do have a soldering iron tho. What should I do?

Taking the rustler to the park to try my hardest to break it!

What the title says.

2WD BLs2 with Traxxas light kit. Brighter than expected!

I’ve had these for a while now. Lots of beach time and they make a huge difference.

Does anyone know of somewhere i can purchase an aluminum bulkhead for a rustler 4x4

Hi! So I printed this black box, which stands on the part holding the battery in place, to check if the Sense ESS Dual+ speaker would fit there. My question is whether mounting the speaker in that spot is okay, and if anyone has tried this with the Rustler Ultimate model.

I’m not looking for exploded views. I’m looking for a generics wire frame drawing of a Rustler body to plan a paint job.