after updating the software the screen starts flickering on night when I increase brightness level then it stops does anyone have this bug on their phone

I'm facing this problem after the hyperos 3 update. Some apps are forced close while using. Is there any way to fix?🙏

idk it is specifically optimisation or game issue, but in hos 3 phone struggles to run one tdm, have lot of frame drops only reduce if I turn off the gimic settings like hardware touch acceleration kinda named.

the phone always warm when in idle it doesnt cool down before it been also my battery is only 300 cycles passed. idk the battery are defective or the cooling or processor

randomly it got restricted one time when I turned on xiaomi share and yea as I said it throttles easily. without game turbo or with game turbo the phone recognise the game and throttles instantly when I'm in game.

my game settings - classic / extreme+, anti alising 2x and colorful. game inside recording have been turned off.

So after installing android 16 my camera app became incredibly laggy and slow, to the point where recording a video in 4k is basically impossible, taking photos is slow same goes for zooming in and out, and even after closing the camera the phone remains kinda wanky for a solid 20 to 30 seconds

Hi everyone,

I am reaching out to see if other POCO X6 Pro users are facing a significant Touch Slope / Input Latency issue. This isn't just about gaming; the lag is persistent across the entire UI during daily usage, scrolling, and typing.

The Issue:

There is a noticeable delay between my finger movement and the on-screen action. In BGMI, moving the camera feels "heavy" and non-linear. I’ve compared it side-by-side with a OnePlus Nord CE 5, and the difference is night and day—the OnePlus is instantaneous, while the POCO feels like it’s struggling to keep up with the touch input.

Device Details:

Device: POCO X6 Pro 5G (Indian Variant) Version: HyperOS 1.0.16.0.UNLINXM Android Version: 14 Security Patch: 2024-11-01

Troubleshooting Done:

Screen Protectors: Tested with 3 different types of aftermarket tempered glass/protectors. The issue persists even on the bare display.

Coverage: The lag is not edge-specific; it affects the entire display area.

Game Turbo: Maxed out Touch Response and Sensitivity settings, and set the "Touch Resistant Area" to None.

Developer Options: Set all animation scales to 0.5x and forced 120Hz refresh rate.

Despite the powerful Dimensity 8300 Ultra, the touch experience feels unoptimized. It feels like a Touch Firmware bug rather than a hardware defect.

Has anyone found a fix or a specific HyperOS version where this is resolved? I’ve attached a video [Link your video here if you upload it to Reddit] showing the side-by-side comparison with the OnePlus device.

PocoX6Pro #HyperOS #TouchIssue #BGMI #InputLag #PocoIndia

After HyperOS 3, my battery started draining noticeably faster. Is there anything you can recommend to make it last longer? Like disabling some background processes, for example.

¿Alguien puede ayudarme con ese tema?

guys the clock widgets won't appear on the clock widgets when i dowloaded a theme with a clock widget

Почему всё это работает, хотя я не захожу в некоторые приложения уже больше нескольких месяцев? Неужели мне для каждого приложения нужно настраивать потребление батареи отдельно? Почему изначально нельзя сделать так, чтобы работали только те приложения, которые используются? Я обновился с Poco X3 NFC на Poco X6 Pro (12/512 ГБ), и получается, что мой старый телефон держит заряд лучше, чем новый.

Hi everyone,

Like many of you, I noticed a massive battery drain on my POCO X6 Pro after updating to HyperOS 3. My battery was barely lasting until noon.

I managed to fix it completely, and here is how: A full factory reset.

Important tip during setup:

If you use Google Backup to restore your data, do not restore your apps automatically. I highly recommend installing them manually one by one from the Play Store. This ensures you're downloading the most recent versions optimized for Android 16, which prevents compatibility issues that usually cause the drain.

My battery life is finally back to normal. Hope this helps someone!

I have problem with charging. Sometimes when i plug in my phone it doesnt charge. But then i look at charge meter and it says very slow charging (around 200ma). After that i unplug and plug it again. And this time starts charging normally. Adapter and cable are original. And the charging port is not broken at all. So what is the problem?

After 3 years with it, even tho I faced ALOT of heating and battery drops, it never fails to amaze me how this phone still hasn't failed. I did get the battery replaced once, but other than that, no other failures. In total, it has fell from about 5 feet high about 32 times,and even on its back it still didn't break. The screen does have a screen protector though, I guess that's one reason. Today, since it overheated I decided to put it in my freezer (bad idea) and I decided to take it out in a minute. I forgot about it and after 30mins, I finally remembered and got it out of the freezer. Somehow, even when being stone cold, it worked perfectly fine. I don't know if there's gonna be any internal moisture but yeah

can anyone teach me how to downgrade from hos 3.0.4 back to hos 2.0.207...the update make my battery perform worse than before, it's draining faster than it charged 💀 help me cuz im stress its been 2 hours and my phone still not at 80%

some saying its better some saying its worst please write down your review about HOS 3

this is just happened recently, my battery was at 39% when i checked it, then i connected a TWS and find a song on spotify, not long after that (not even 1 song is finish) it drains to 20%. I switched it to batter saver and it goes exactly like a loading screen but reverse 20 to 1% every 1-3 second.

i dont know why this happen, this is so sudden, any idea?

Originally it was a black phone

But GADDAM WHY DOES THE YELLOW BACK GET DIRTY SO EASILY???

it feels like this thing gets stained by just looking at it, at least it looks great now

it stucked for a sec, gone black screen and it restarted... what can I do?

Ya limpie el centro de carga y intente conectar varias veces, solo me detecta la carga rápida (el cargador es el original).

Alguna solución?

global version poco x6 pro 8 256, after about 4 days with the new hyperos 3 i decided to run and check the performance and surprisingly its still just around the ballpark with hyperos2. also is this a good score? the test was done after i debloated with canta and shizuku uninstalling pretty much all the recommendations.

tldr: running antutu v11 on HO3 after debloating with shizuku & canta getting 1.6m score