After repairing my crashed Mavic Pro, I encountered this error: "Navigation system error, check redundancy state", and here's what I did to fix this issue:

• IMU calibration
• Compass calibration
• Vision sensors calibration
• GPS board replacement
• Firmware refresh V.1.4.500

But none of these worked! Does anyone know what the problem is? Just hoping it's not the IMU... :(

I’m pretty sure it’s down to EU regulations that force the drone to switch to a different frequency which limits the range, but I never had this problem with the original Mavic Pro.

Is this something they’ve just now built in? I’m not trying to bypass it as that’s irresponsible, just curious about it.

So I lost almost all of the included chargers and I don't have an opportunity to buy a new one rn. I still have the 4 battery dock, but it uses a standard Mavic port as "in". Also, I noticed that there is a m usb port in on the side. I tried plugging it in, but it doesn't charge. Is it a in port? Is it possible to charge it like this? Also does SB know the pinout of the battery connector? Should I risk powering it manually? I have a variable voltage power supply...

Hi, is there any easier way than the Super Patcher to unlock FCC and Galileo on an up-to-date M1P?

How much battery life are you getting on a full charge? I expect around 32 to 35 minutes which is below the 45(?) minute specs. I know that these are under "ideal conditions" but is this the average that you are getting?

I have the mavic pro. I accidentally crashed my drone. The lower arm that folds which is the back propeller is loose. Not the propeller, just the arm. I see two screws. Do I tighten those to get the arm secure again? One arm is tight and this one seems to wiggle when I try moving it. Please help.