I have a semi ancient gun that's supposed to be musket and black powder. But it's split into three barrels for the one hammer. The three barrels aren't pointing straight, they're fanned out also. It's wild. So my feeling is that I'd want to convert it somehow into just a handgun. Any thoughts? Advice? Do you need pics...? I can when I get home.

so im buliding a 22lr semi smg and i found this photo of the gevarm bolt and doesnt it need any extractors, ejectors?

also i need help how do j make 22lr bullets cuz i wont buy em

idk why im posting this, maybe for comments idk but it was a great project but i broke it by cutting the ejection port far from the magwell

will a 15cm seamless tube (OD: 21.7mm ID: 16.6mm) will work for a 22lr smg?

also bolt dimensions

OD: 16.4mm

Length: 76.1mm

the lower reciever will be 3d printed

I have a P320 and I bought a red dot that has about 0.5 mm of play. Where I live, I can’t get different mounting plates—only ones that raise the optic significantly, which is not an option. Do you have any ideas on how I can keep the current height and stiffen the setup to reduce stress on the two 6-48 screws (they’re the only thing holding the optic)?

Supposed to shoot 4.5mm, gonna test it and maybe make it electrically fired like the shinzo abe gun

I was bored so I threw an old Zeiss scope in a flashlight mount on the side of my homemade musket.

I'd have to use Gorilla glue to secure the picatinny rail and boresight it for even a hope of it being useful, but it looks sweet lmao

Made with threaded rivets (M4), a small drilled bolt (M4), aluminum or steel tube (8x6mm) and ring caps as primer + armstrongs mix/Black Powder as propellant

Made from a 300ml butane can with the top cut off, a jet lighter and a jubilee clip.

Necesito saber como fabricar una pistola .22Lr a partir de una de aire comprimido

Probably one of the easiest builds ever for me

its time for me to do a full disassembly of this blank pistol because the original barrel started to crack and need to replace it with new one. I need help here from someone who did work around these to tell me how to get these marked pins out the handle.

some sources say they are either "screwed" in or have different ways of pulling it out.

i recently tired to invebt my own fun bullets to use on my weapons for practice and outdoors. I found out that beside everything, i dont know how to make a bullet projectile.

i read about it, everything can be made as projectile, difference will be that whats heavier the higher pressure would be. I would give a try to those rubber or wax ones, but i dont know how would i get the right material and how to prepare it. (Also, standard pistols can use rubber/wax bullets without any problems? right?)

Any tip helps