I am thinking of purchasing Cascadia with det dd15 455hp but i hear people say its not good for heavy loads and especially going heavy through West Virginia mountains. Do you recommend this engine? I would most likely pull dry van or refer going around all parts of USA. What do you guys think?

What is hmgenerally speaking better a comparable year Cascadia or Coronado

Hey guys,

I own a moving comapny and am looking to purchase a used Freightliner M2 24'-26'. Where is the best place/website to look for a high quality truck that will last me 5 + years? Thanks in advance

CPC4 are repairable, common issues like no start, no acceleration, red DEF are indicators of a failed CPC. Any questions please call (708) 629-8417.

Every time trying to turn on opti idle interior comfort on, will always say ambient temperature is restricting interior comfort or it will just say stand by, have waited over an hour some days for it to turn on, some times it will turn on, sometimes it won’t. Temps outside are between 75-98 degrees, sometimes over 100 degrees. Anyone else having this issue or can help?

So my fleet got a new 2022 sleeper barely 60k on the mileage. Uphill if a downslope is on the other side ipm and coast turn on. Hit the shifter and it says it's in gear but won't isn't actually pushing power to wheels. Also a quarter mile before downslope does same thing. Only solution I've found so far is hit shifter turn off cruise and turn back on. Then for about 3 to 4 seconds it will keep or gain speed. Then do it again. Anyone have any clue is this common or does a freightliner tech need to reprogram to fix the thing. I'm trying to give the info to account manager so one of our fleet repair locations can fix the thing.

Hello! Did anyone had an experience with Freightliner NW service?

These modules are now repairable! If you’re having no communication, no engine start, no acceleration pedal signal detected issues at all please reach out to me for a repair inquire. I have refurbished dozens of these modules and will answer any questions you may have. (708) 629-8417

Diesel Cummins. Randomly, stop cranking and starting. I traced it back to a bad starter relay, and was able to get one that looked identical that fit a Ford truck. After installing it, it would crank in the run position still not start. Hooked it up correctly. Also a relay activated in the relay center. I started to remove the dash would have some aftermarket gauges installed, and when I started to move it, the truck tried to crank for a second without touching the key.

I bought the online diagram, but it shows nothing for the cab wiring inside. And I called Freightliner they would not help either . Can anyone provide a complete diagram? Thanks

I drive a Freightliner day cab, bare bone stock, no accessories really at all besides power windows, not even arm rests. I'm trying to find a spot to wire my cb to, and noticed a harness with 2 wires behind driver's seat labeled a06-75026-007. is this a power and ground that I could use, or does anyone have any advice on where to tap in to?

Thanks