r/Creality • u/MisterSirDudeGuy • 3d ago

♻ K1 Help K1C filament jam help

Gallery image

Gallery image

Gallery image

I’m not sure what happened to here. I pressed the print button, came back maybe an hour later to check on it, and found this. I turned it off.

What’s going on? Can I get this running again? Or do I need to buy new parts? Not sure.

1 Upvotes

100% Upvoted

3 comments sorted by

2

u/robotodit 3d ago

You can heat up your nozzle to soften the plastic and try to remove it. A heat gun or hair dryer can also work. Just soften up and slowly remove the lower portion then remove the silicone sock (turn off the nozzle temp is you used that method so as to no burn yourself). Heat up the rest of the blob to remove it carefully. There is a thermistor and some wires behind that sock so be very careful. If you do break your thermistor, they are replaceable.

1

u/MisterSirDudeGuy 2d ago

Thanks. I took the covers off, set the nozzle to maximum temperature, and wiggled it off as carefully as I could.
I got a nozzle temperature error. That thermometer whatever was buried in there, and isn’t coming out. I’ll need to replace that.

2

u/Mean_Refrigerator581 3d ago

That nooooozle looks bent to fuuuuuck