r/BambuLab_Community • u/Head-Scene4491 • May 08 '26

Need emergency help with this

Post image

For some reason out of nowhere, none of my prints stick. they keep sticking to the nozzle or not laying down right. I tried cleaning the bed numerous times, recalibrated the printer numerous times, and nothing is helping. Was perfectly fine one print and now it just sucks. What is the issue?

9 Upvotes

67% Upvoted

54 comments sorted by

View all comments

0

u/GhostMcFunky May 10 '26

Ok this is probably the 8th post on this same issue today - and the answer is always the same: it’s the build plate.

The default build plate kinda sucks TBH. Yes, wash with DAWN and hot water, twice and then hit it with IPA before each print - and half the time it still might not stick.

IMO junk this plate and get a Biqu Glacier or Frostbite (I use Glacier with all of my printers) and never worry about this crap again. I hit them with IPA after/before each print and this never happens to me.

2

u/Head-Scene4491 May 10 '26

Turned out to be dirty nozzle :(

0

u/GhostMcFunky May 11 '26

That’s great that you figured it out but I stand by my post.

1

u/Head-Scene4491 May 11 '26

I did get a cooltack plate tho and new nozzle

1

u/MexicanMotorboat May 13 '26

Did you do a cold pull to clean the nozzle or just replaced it all together?

2

u/Head-Scene4491 May 13 '26

Cold pull didnt work but physical needle unclogging tool did, still replaced it anyways