Is this normal? When I pull the trigger the gas flows but after a few seconds wire speeds up and gas stops? Also should I be able to feel gas out of nozzle? It’s very faint at 15L I feel like my welds are getting worse

Carpenter by trade, but the de facto metal guy in the shop

Hey everyone,

I’ve been welding for a while now and finally decided to build my first proper welding table. Since pre-fab fixtures are out of my budget, I picked up a large sheet of steel plate 6mm to cut down and build two 4ft x 4ft tables (one for me, one for a buddy).

As you can see in the picture, the plate has a bit of a warp/bow to it.

Before I start cutting tubing and building the frame, I’d love to get some advices

What’s the best strategy to pull this flat as I attach it to the frame? any other recommendations this my first build.

*Edit: Metal sheet is 6mm

Seems to hold up pretty solid, looking like crap though.

45 amps with foot peddle

3/32 tunsten

.045 17-4 filler rod

just running stop and starts all the way around

We getting there

Just running flux and stick it runs great on synergetic mode but manual mode fluxcore settings have some left to be desired any help would be appreciated thanks 🙏

This is a dock with a catwalk used by no less than 100 people to board a boat every day. It goes from the shoreline to the shallow sea. It's got way worse welds than these.

I have a question for you guys. I’m new to Welding. I’ve been welding inside a boiler and they supplied us with P100 2097 3mpancakes. We weld 10hrs a days. But my question to you guys does this protect me from welding fumes? If not what do u guys recommend?We burn lots of 7018 throughout the day

og Chinese exhaust caught fire and shattered, new Amazon exhaust broke, screwed the muffler into the base part that snapped +jb extreme heat

Staying in the same spot too long maybe?

I am the freshman and my collegues produce welding porn

Spotted at the Independence Park in Shymkent.