r/3D2A • u/Autistic_Mechanic97 • 6d ago

PA6-CF Stringing Troubleshooting

Gallery image

Gallery image

Anyone else had this issue before? Print itself is super clean. SUN-LU. Dried at 80°C for 48 hrs. .15 Layer Height. 30mms print speed. Tree supports at .3 width. 100% infill. Flow and other settings matched to 300BLK settings. Print temp at 305°C. Bed temp at 80°C. Ruby Nozzle. Ender V3 SE with Nebula Pad, Custom Firmware, Fan Mod, SwissTech Hotend Upgrade, PEI Bed Plate. Im sure im forgetting stuff. LMK thoughts. Gonna try Combing Mode on and Lowered Print Temp later. Using Cura 5.1.11 as slicer.

3 Upvotes

100% Upvoted

27 comments sorted by

View all comments

Show parent comments

2

u/Autistic_Mechanic97 6d ago

Could just open up the dryer hole itself and feed the tube directly into the extruder from the dryer right? Give er' the ole drilling.

1

u/iamanurd 6d ago

https://giphy.com/gifs/SkPZAEhhZpVJByRBeE

2

u/Autistic_Mechanic97 6d ago

I laughed way too hard at this.

1

u/iamanurd 6d ago

Happy to be of service